مساعدة كورس كامل لبرنامج CAMWorks , مبسط و بالتفصيل

A-Turning

1-


1-1 Introduction -CAMWorks Interface (CAMWorks Tutorials)

1-2 Introduction -Process Overview (CAMWorks Tutorials)

2-1 Turning - Introduction (CAMWorks Tutorials)

2-2 Turning - Define the Machine (CAMWorks Tutorials)

2-3 Turning- The Setup Tab (CAMWorks Tutorials)

2-4 Turning - Define the Stock Bar Stock (CAMWorks Tutorials)

2-5 Turning - Define the Stock Revolved Sketch (CAMWorks Tutorials)

2-6 Turning - Define Features Automatically (CAMWorks Tutorials)

2-7 Turning - Define Features Interactively (CAMWorks Tutorials)

2-8 Turning -Generating an Operation Plan (CAMWorks Tutorials)

2-9 Turning -Generating Toolpaths (CAMWorks Tutorials)

2-10 Turning -Simulate Toolpaths (CAMWorks Tutorials)

2-11 Turning -Tool Adjustments (CAMWorks Tutorials)

2-12 Turning -Roughing Options (CAMWorks Tutorials)

2-13 Turning -Finishing Options (CAMWorks Tutorials)

2-14 Turning -Rough Grooving Options (CAMWorks Tutorials)
2-15 Turning- Finish Grooving Options (CAMWorks Tutorials)

2-16 Turning -NC Options (CAMWorks Tutorials)

2-17 Turning-Lead In Lead Out Optins (CAMWorks Tutorials)

2-18 Turning - Create Setup Sheets (CAMWorks Tutorials)

2-19 Turning- Post Processing (CAMWorks Tutorials)

2-20 Turning- Inserting Operations (CAMWorks Tutorials)

2-21 Turning - Setting up a Chuck (CAMWorks Tutorials)

3-1 Turning Exercise Part Exercise 1A (CAMWorks Tutorials)

3-2 Turning Exercise - Part Exercise 1B (CAMWorks Tutorials)

3-3 Turning Exercise - Part Exercise 1C (CAMWorks Tutorials)

4-1 Turn Features - Face Feature (CAMWorks Tutorials)

4-2 Turn Features - OD Feature (CAMWorks Tutorials)

4-3 Turn Features - Grooves (CAMWorks Tutorials)

4-4 Turn Features - ID Feature (CAMWorks Tutorials)

4-5 Turn Features - Cutoff Feature (CAMWorks Tutorials)